Aside from some small adjustments, it appears everything will fit together well. The plastic outer wing is a very good quality part.
Square hole on the inner wing near the headlight is the air intake for the Kodiak Mk.II heater.
Thursday, October 6, 2011
Wing Test Fit
As anything needing painting is on the fast track these days, and while the hood/bonnet frame dries in preparation for primer tomorrow, thought I'd do a test fit of the right wing, along with the ABS plastic outer wing. Didn't really fasten anything together, just enough to hold things in place. Had to do quite a bit of panel beating first on the inner wing, as it was more damaged that previously thought, but eventually it came together. Hope to do a test fit of the other wing tomorrow.
Aside from some small adjustments, it appears everything will fit together well. The plastic outer wing is a very good quality part.
Square hole on the inner wing near the headlight is the air intake for the Kodiak Mk.II heater.
Aside from some small adjustments, it appears everything will fit together well. The plastic outer wing is a very good quality part.
Square hole on the inner wing near the headlight is the air intake for the Kodiak Mk.II heater.
Subscribe to:
Posts (Atom)